2026-09-14 21:18 UTC
@scarlett@gamepad.club Don't be mad, was thinking about this and remembered they usually do this arc so there's no corners in the lighting.
So tried making and #3dprinting my own 😆
Version one tends to tip, sadly.
Replies (1)
-
@purrpurr@mastodon.social 2026-09-16 18:34
For version 2 I extended the trunnion, made it thicker, and added a little support on the back. Works fine now. It can almost hold up and entire sheet even! @scarlett@gamepad.club Sorry again for high-jacking your post. I'll make my own next time, promise. #3dprinting