Well, I have my summer project, something to do while I dehydrate, get ready for another thread of amateur luthiery. . Big plans to do what I haven’t quite yet: for starters I’d like to get the neck off without splitting one side, I’ve done that with both of my Framuses, acoustic and electric. On the electric I chiseled the old joint out and on my acoustic I did that too the first time. This time it was my first block to remove and I did that with water, and the whole joint had been exposed and reset before so I could open it up some, rebuild what I had destroyed the first time. . That doesn’t look to be the case with this one, I think the top is intact and of coarse I’d like to keep it that way, so there’s no access inside for deconstruction, I think I’ll have to leave the internal part of the old joint in, just saw the neck off from the outside and somehow build around the internal part of the joint for my block. . I want some playdough or something with which I can take 3D impressions of the inside. . /2 #Guitar #Framus12StringProject